Changes

Jump to: navigation, search

ECB Bus

72 bytes added, 12:45, 29 September 2010
/* ECB Bus Pin-Outs */
|}
Signals in brackets "(...)" aren't available on all ECB variants; the Schneiderware series doesn't support those signals. Moreover, the Schneiderware pin-outs are somewhat customized: Signals HALT, M1, INT, are mapped to wrong pin numbers, -12V complies with some ECB variants, and some non-ECB signals SOUND, CURSOR, LPEN, EXP, ROMEN, ROMDIS, RAMRD, RAMDIS are added, and, UBAT is listed as 5V in Schneiderware (normally it should be 2V..3V) (though UBAT isn't actually used/connected on the Schneiderware boards). Aside from the +5V, +12V, -12V supply voltages, the Schneiderware motherboard also has an "AC" soldering point; it's voltage/purpose and it's ECB-pin number are unknown -- it might possibly refer to the ACCU battery (rather than to a analog current AC voltage). The CPC's two Reset signals (BUSRESET and RESET) are mapped to the corresponding ECB-locations (not sure if they are assigned correctly, or if they should be exchanged with each other).
== Files ==
6,388
edits