Difference between revisions of "Dobbertin Smart Watch"

Revision as of 19:22, 13 December 2012

The Dobbertin Smart Watch was produced by Dobbertin Industrie Elektronik, a German company. This real time clock was relative wide spread in the 80ies and 90ies.

Technicals

The SmartWatch consists out of the RTC itself and an EPROM expansion with a lot of RSX commends. The RTC itself was inserted like an EPROM in any kind of ROM or EPROM card. Further it contains a little battery. At least one clock is still running in 2010!

Dallas Semiconductors SmartWatch

The 28pin SmartWatch (DS1216) is an adapter that can inserted in standard ROM sockets, a ROM chip can be mounted on the adapter, finally, inside of the adapter is a 16pin Phantom Time Chip (DS1315). Normal memory reads are forwarded to the piggyback ROM. After reading from a specific sequence of addresses, the ROM is disabled, and data is instead read from the Phantom Chip via 1bit databus. Writing to the Phantom Chip is done by reading from a specific sequence of addresses, too.

• DS1216-smart-watch.pdf - Dallas Datasheet for 28pin SmartWatch Adapter
• DS1315-phantom-time-chip.pdf - Dallas Datasheet for 16pin Phantom Time Chip
• DS1216-app-note-52.pdf - Dallas Application Note on SmartWatch and Phantom Time Chip

64bit packets

Accessing the RTC is done by following steps

• Read 1 or more bits (this resets the recognition pattern; best read at least 64 bits, in case the chip was in the 64-bit data read phase)
• Write the 8-byte (64bit) recognition pattern
• Read or Write the 8-byte (64bit) register data

The 8-byte (64bit) pattern/data is transferred serially, LSB first. The used bits on address and databus are:

A2 data direction (0=write, 1=read)
A0 data written to RTC, when A2=0=write
D0 data read from RTC, when A2=1=read, and only when pattern recognized

Recognition Pattern

The recognition pattern is: C5h, 3Ah, A3h, 5Ch, C5h, 3Ah, A3h, 5Ch.

Register 0..7

0  1/100 Seconds (BCD 00h..99h)
1  Seconds       (BCD 00h..59h) (Bit7=Zero)
2  Minutes       (BCD 00h..59h) (Bit7=Zero)
3  Hours         (BCD 01h..12h or 00h..23h) (Bit5=PM when Bit7=12-hour mode) (Bit6=Zero)
4  Day of Week   (01h..07h) (Bit4=Disable Reset input, Bit5=Disable OSC, stop clock) (Bit3,6,7=Zero)
5  Day           (BCD 01h..31h) (Bit6-7=Zero)
6  Month         (BCD 01h..12h) (Bit5-7=Zero)
7  Year          (BCD 00h..99h)

Pictures

Downloads

• TIME ROM+ ROM file
• (disc with CP/M driver) - none such...?

Software

• The TimeROM+ Software provides RSX commands to use the RTC under BASIC.
• Support for CP/M Plus is provided. The TIMEROM+.COM program sets the software clock according to the RTC.
• The Smart Watch is also supported by FutureOS.