Difference between revisions of "User:Deriss"
| Line 12: | Line 12: | ||
Now carefully remove the case.. Be '''VERY''' careful with any keyboard membranes. You '''CANNOT''' buy these anymore. | Now carefully remove the case.. Be '''VERY''' careful with any keyboard membranes. You '''CANNOT''' buy these anymore. | ||
| + | |||
eBay is The best source for spare chips and other replacement components that I have found, btw. | eBay is The best source for spare chips and other replacement components that I have found, btw. | ||
| Line 32: | Line 33: | ||
to buy online if you look long enough. | to buy online if you look long enough. | ||
| − | 6: Check for damage to the edges of the board. these can often be fixed with a few wires to re-route broken tracks. | + | 6: Check for damage to the tracks at the edges of the board. these can often be fixed with a few wires soldered to |
| + | nearby points, to re-route the voltage around broken tracks and back where it was supposed to go. | ||
| Line 38: | Line 40: | ||
Capacitors and resistors are too cheap to mention. FYI: buying a bag of 5 is frequently little more expensive than buying just | Capacitors and resistors are too cheap to mention. FYI: buying a bag of 5 is frequently little more expensive than buying just | ||
| − | 1 or 2. Then you have spares as well. 85c rated parts are fine. 105c is excessive | + | 1 or 2. Then you have spares as well. 85c rated parts are fine. 105c is also fine but excessive. |
The Z80 cpu can be easily replaced for as little as £3 new, as can the 8255AP-5 interface chip and the AY-3-8912 audio chip. | The Z80 cpu can be easily replaced for as little as £3 new, as can the 8255AP-5 interface chip and the AY-3-8912 audio chip. | ||
| − | The CRT controller UM6845R is about £4.50. They are all | + | The CRT controller UM6845R is about £4.50. They are all made by several different manufacturers, with very slightly |
| − | that is over priced. | + | differing model numbers for what is actually the same product. So shop around first and check the specs/pinouts before buying one |
| + | that is over priced. Compare at the chip model numbers on the cpc wiki mainboard images to check what will and wont work. | ||
| + | For example, the same CRT chip is listed under three sets of models numbers and manufacturers. | ||
| + | |||
| + | Memory (DRAM) is quite easy to source from eBay as there are a surprising number of UK suppliers who have stocks of | ||
| + | 4164 or 4264 dram chips | ||
The Gate Arrays, either Amstrad 40007 or 40010, are the only expensive parts at between £8 and £15. | The Gate Arrays, either Amstrad 40007 or 40010, are the only expensive parts at between £8 and £15. | ||
| − | It's a suppliers market for these unfortunately.. The two models NOT interchangeable as they have different pinouts, | + | It's a suppliers market for these unfortunately.. The two models NOT interchangeable as they have different |
| − | even though some boards made potential allowance for either chip in their designs. | + | pinouts, even though some boards made potential allowance for either chip in their designs. |
| − | For the floppy control circuitry, the NEC 765 controller can still be acquired but the SEC9420C buffer is a hard one to track down. Luckily these are virtually never needed as you are likely to have replaced everything else before getting round to that anyway. | + | For the floppy control circuitry, the NEC 765 controller can still be acquired but the SEC9420C buffer is a hard one to track down. |
| + | Luckily these are virtually never needed as you are likely to have replaced everything else before getting round to that anyway. | ||
| − | The last models of 464/6128 (1989/90) had an integrated SMD chip that removed the need for a gate array. They were known as the "cost-down" boards. These chips physically cannot be swapped out and so would render any such board as scrap, if it turned out to be the SMD chip. Avoid any major expenditure on these boards, that cannot be recouped via eBay anyway. | + | The last models of 464/6128 (1989/90) had an integrated SMD chip that removed the need for a gate array. They were known as |
| + | the "cost-down" boards. These chips physically cannot be swapped out and so would render any such board as scrap, if it turned | ||
| + | out to be the SMD chip. Avoid any major expenditure on these boards, that cannot be recouped via eBay anyway. | ||
Revision as of 12:00, 4 April 2017
Bought a 464 or 6128 from eBay ? Broken or not working right ? Read on..
Firstly, make sure you have a 5v regulated power supply and that your monitor / tv are working ok. (You'd be surprised...)
Make sure your power supply provides a minimum of 2A continuous current. Some PSUs can be very "optimistic".
On the 6128, you don't need a 12v feed for anything except the 3" disk drive. So it can be omitted for testing.
Earth yourself to prevent static damage or better yet, get an anti-static strap. It's a 30 year old machine remember...
Now carefully remove the case.. Be VERY careful with any keyboard membranes. You CANNOT buy these anymore.
eBay is The best source for spare chips and other replacement components that I have found, btw.
The obvious things on the board to look for first are:
1: check the 5v power and 6pin display sockets for dry solder joints. A dab of fresh solder will fix this.
2: check the rest of the board for dry joints too. This can be tedious but is worth it in the long run. Never touch the soldering iron tip to a joint for longer than 2 seconds to avoid damaging sensitive components.
3: Check for any damaged or leaking capacitors. Check the ceramic ones too, in case a previous owner has knocked and damaged one. Remember to replace any capacitor with a product of equal or higher voltage rating. Equivalent ones are nowadays frequently physically much smaller than the 1980's originals. So don't be surprised.
4: examine all resistors for signs or damage or discolouration. check resistance with multi meter and replace as needed.
5: Examine all the chips for any corrosion, damage or discolouration. Virtually all the components are still available to buy online if you look long enough.
6: Check for damage to the tracks at the edges of the board. these can often be fixed with a few wires soldered to nearby points, to re-route the voltage around broken tracks and back where it was supposed to go.
REPLACEMENT PARTS :
Capacitors and resistors are too cheap to mention. FYI: buying a bag of 5 is frequently little more expensive than buying just 1 or 2. Then you have spares as well. 85c rated parts are fine. 105c is also fine but excessive.
The Z80 cpu can be easily replaced for as little as £3 new, as can the 8255AP-5 interface chip and the AY-3-8912 audio chip. The CRT controller UM6845R is about £4.50. They are all made by several different manufacturers, with very slightly differing model numbers for what is actually the same product. So shop around first and check the specs/pinouts before buying one that is over priced. Compare at the chip model numbers on the cpc wiki mainboard images to check what will and wont work. For example, the same CRT chip is listed under three sets of models numbers and manufacturers.
Memory (DRAM) is quite easy to source from eBay as there are a surprising number of UK suppliers who have stocks of 4164 or 4264 dram chips
The Gate Arrays, either Amstrad 40007 or 40010, are the only expensive parts at between £8 and £15. It's a suppliers market for these unfortunately.. The two models NOT interchangeable as they have different pinouts, even though some boards made potential allowance for either chip in their designs.
For the floppy control circuitry, the NEC 765 controller can still be acquired but the SEC9420C buffer is a hard one to track down. Luckily these are virtually never needed as you are likely to have replaced everything else before getting round to that anyway.
The last models of 464/6128 (1989/90) had an integrated SMD chip that removed the need for a gate array. They were known as the "cost-down" boards. These chips physically cannot be swapped out and so would render any such board as scrap, if it turned out to be the SMD chip. Avoid any major expenditure on these boards, that cannot be recouped via eBay anyway.
